Vision T40, Owner'S Manual

14

15

T40

onlY

T40

 assemBlY 

STEP 3

BOLT (A)

SPRING WASHER (B)

BOLT (F)

HANDLEBAR

SUPPORT BAR

BASE FRAME

ARC WASHER (E)

SPRING WASHER (B)

ARC WASHER (E)

T40 HARdWARE fOR STEP 3

 :

noTe: This step is for T40 models only.

a 

open 

hardware for step 3

. 

B 

attach the right 

support bar

 to the 

base 

frame

 using 1 

arc washer (e)

, 1 

spring 

washer (b) 

and 1 

bolt (f)

.

noTe: do not tighten bolts until step 4 is complete.

C 

attach the right 

support bar

 to the 

handlebar

 using 1 

arc washer (e)

, 1 

spring washer (b) 

and 1 

bolt (a)

.

d 

Repeat on other side.

BOLT (A)
20 mm
Qty: 2

SPRING
WASHER (B)
8.2 mm
Qty: 4

ARC
WASHER (E)
8.4 mm
Qty: 4

BOLT (F)
95 mm
Qty: 2

assemBlY 

STEP 2

BOLT (A)
20 mm
Qty: 6

SPRING
WASHER (B)
8.2 mm
Qty: 6

ARC
WASHER (C)
8.4 mm
Qty: 4

FLAT
WASHER (D)
8.2 mm
Qty: 2

HARdWARE fOR STEP 2

 :

FLAT WASHER (D)

SPRING WASHER (B)

ARC WASHERS (C)

BOLT (A)

RIGHT HANDLEBAR

CONSOLE CABLES

RIGHT CONSOLE MAST

a 

open 

hardware for step 2

. 

B  guide 

console cables

 from 

handlebars

through and out of the tops of the 

console 

masts

.

C  slide 

handlebars

 onto 

console masts

.

d  attach right 

handlebar

 to right 

console 

mast

 using 1 

flat washer (d)

, 1 

spring 

washer (b)

 and 1 

bolt (a)

 from the inside and 

2 

arc washers (c)

, 2 

spring washers (b)

and 2 

bolts (a)

 from below.

e 

Repeat on other side.

noTe: do not pinch console cables while 

attaching the handlebars.

T40 SHOWN

all

models

T40 ONly

noTe: do not tighten bolts until step 4 is complete.