Read all instructions in this User Manual and on the
product carefully BEFORE operating this device.
•
The latest version of this handbook can be found at
www.vision-products.co.uk
•
Many Vision products are intended for indoor use only.
Under no circumstances must these products be used
outdoors unless explicitly stated otherwise.
•
Clean the exterior of the product with a clean and dry,
non-abrasive cloth. Do not use solvents or liquids to clean
the product.
•
There are no user replacement parts inside the product.
Do not open the product for any reason. This will
invalidate your Manufacturer Warranty and may impair
the safety features of the product.
•
Do not use the product if you suspect it has been
damaged in any way, including being dropped, is
malfunctioning or has been exposed to liquids or
moisture.
•
The unit must be repaired by an authorised service centre
only.
•
Manufacturer Warranty is void if unit is opened or
adapted in any way.
•
If the product appears to be malfunctioning or operating
in an unexpected manner, stop using the unit immediately
and contact your supplier.
•
Never lift, move or carry the product by any other means
other than the case as a whole or handle if provided.
This product complies with the relevant clauses of the European
Directive 2002/96/EC. The unit must be recycled or discarded
according to applicable local and national regulations.
Equipment intended for indoor use only. Vision Products (Europe)
Ltd confirms that this product is in accordance to following norms
of EU EMC norm EN50083-2 and safety norm EN60065.
3
Please note this product may be improved or updated without notice. Please refer to your
supplier before purchasing. Examples shown and the possible faults indicated in those
examples are suggestions only. It is the operator’s sole responsibility to ensure the correct
conclusions are drawn from any tests or test results.
Coax cables, electronic products and connectors etc. may not be able to sustain the maximum
operating parameters of this tester and great care must be taken to ensure the specifications
and limitations of peripheral items are not exceeded. E&OE.
