Introduction
Thanks for choosing the wireless garage contact of the home security device.
This sensor monitors garage when garage is opened and closed.
Product Description and Specification
*** For indoor use only***
Specification:
Package Content:
Protocol: 319.5MHz
1pc
WGC-Q sensor
Operating Range: Up to 200 feet line of sight
1pc
CR123A Lithium Battery
Operating Temp.: -15
°
C~ 60
°
C (5
°
F ~140
°
F)
1pc
Installation & Operation manual
Battery: Panasonic CR123A * 1PC
Installation
1. Unscrew the screw fastening the rear cover.
2. Slide the rear cover down.
3. Using the screws or adhesive tape to affix the rear cover on the frame along the
opening edge of garage.
4. Before insert the battery, put home security controller into learning mode. Once put on
CR123A battery into the battery compartment and LED will flash 5 times, and WGC-Q
garage contact will automotive included into system.
5. Slide back the rear cover and screw fastening with the front cove.
6. External Switch: You could use an external switch to connect with the WGC-Q for
extending detection. The WGC-Q has 2 normally closed contact terminals. These can be
used for external switch wired contacts. The external switch will send an alarm report by
opening the garage.
Operation
1.
Opening the garage to separate the magnet from the sensor will send signal to the
controller, and the LED will flash 5 times
2.
Normal operation, the LED will not light.
3.
The WGC-Q sensor equipped with tamper switch. If the cover of sensor is removed, the
garage contact will report
a zone tamper to the controller, and the LED will flash 5 times.
4.
If garage contact is in low battery status, it will report a message to controller, and LED
will flash slow. Please change the battery.
