S
CANNING
WITH
THE
W
INDOWS
I
MAGE
A
CQUISITION
121
9. Adjust settings of the previewed image as desired:
■
Change the button selection for the type of image.
■
Adjust the custom settings; refer to the next section, “Fine
Tuning Your Scans”.
■
Change the size of the scanned image. To do this, click and hold
the mouse pointer over one of the four sizing-boxes on the
corners of the previewed image. Then drag the box to increase or
decrease the size of the image.
10. Preview the image again. When you are satisfied with the image,
click the
Scan
button.
If the
Single page items
check box is selected on the Scan pane, the
scanned item appears as a thumbnail on the PaperPort desktop.
11. If the
Single page items
check box is not selected, thumbnails do
not appear until you indicate the scanning job is finished.
12. On the PaperPort - Scan message box, click
Done.
Note
: If you preview when scanning a stack of documents, the first
page of the stack feeds through the ADF for the preview. After
adjusting the scanner settings, replace that page on the stack so it is
scanned with the rest of the pages.
Note
: Refer to “The Single Page Items Check Box” on page 104.
Summary of Contents for Strobe XP 470
