Visionis VIS-3002, User Manual

8

8.18.1 Normal mode (factory default) 

8.18 Setting safe mode

Press  35

  0  # 

Every time a valid card/tag read or PIN input, the relay will operate, for the pre-set relay 

pulse time. (Factory default setting) 

Every time a valid card/tag read or PIN input, the relay changes state, which will not turn

back until read card/tag or input PIN again

Note: It is only for card entry mode (Factory default setting : 1, card quantity “1-10”)

Note: The card number must be consecutive card quantity is between 1~2000; card number 

is 10 digits or 8 digits

8.12 Set opening door by multi cards

8.13 Add a series consecutive cards users

Press  15

  1  # 

Relay setting-Toggle mode

Press  16   card quantity   # 

Press  17  ID number  #  card number   #   card quantity  #

8.14 system setting

8.14.1 To set facility code

Note: Code should be 0~15, factory default setting: 0 

8.14.2 Wiegand Reader Mode (Wiegand 26) 

8.14.3 Standalone Mode (Factory default setting)  

8.14.4 Anti-passback Mode  

Press  31  0  # 

Press  31  1  # 

Press  31

  5

  # 

Press  30  0~15

   #

8.15 To set wiegand format

Press  32  26  # 
Note: factory default setting: WG26 

8.16 Setting keypad transmission format

8.17 Setting alarm time

Note: Keypad transmission format is 0 1 2, factory default is 0 

Press  33  0~2   #  (Unable to initialize)

Note: 1. factory default is 1 minute 

Press  34  1~3   #  (Unable to initialize)