Fingerprint Access Control Terminal User Manual
107
6. Optional: Set
Enable T&A Status
switch to on to calculate according to attendance status of the
device.
Note
This function should be supported by the device.
7. Set the related attendance time parameters as the following:
Start/End-Work Time
Set the start-work time and end-work-time.
Valid Check-in/out Time
On the time bar, adjust the yellow bar to set the timetable during which the check-in or
check-out is valid.
Calculated as
Set the duration calculated as the actual work duration.
Late/Early Leave Allowable
Set the timetable for late or early leave.
8. Set absence related parameters.
Check-In, Late for
You can set the late time duration for the employee who has checked in but is late for work. If
the employee exceeds the required time period, his/her attendance data will be marked as
absent.
Check-Out, Early Leave for
You can set the early leave time duration for the employee who checks out earlier than the
normal leave time, and his/her attendance data will be marked as absent.
No Check-in
If the employee does not check in, his/her attendance data may be marked as absent or late.
No Check-Out
If the employee does not check out, his/her attendance data may be marked as absent or
early leave.
9. Click
Save
to add the timetable.
10. Optional: Perform one or more following operations after adding timetable.
Edit Timetable
Select a timetable from the list to edit related information.
Delete Timetable
Select a timetable from the list and click
Delete
to delete it.
8.9.3 Add Shift
You can add shift for employees including setting shift period (day, week, month) and the effective
Summary of Contents for VIS-3013
Page 2: ......
Page 21: ...Fingerprint Access Control Terminal User Manual 7 Figure 4 1 Terminal Diagram...
Page 156: ......
