www.visonic.com
Page 10 of 11
D-306783 ioXpander-12x4 Module (Rev 2, 11/17)
7.
Product Specifications
Electrical
Power Requirements
12VDC (Normal), 10.8VDC (Min.), 15VDC (Max)
Output Power
12VDC, 500mA (Max)
Circuit Board
Device Interfaces
1 - four position terminal block RS-485 data bus & power; 11 - three-position removable terminal blocks; 1 two
position output terminal block; 4 - Relay Outputs/LEDs; 1 - Power LED; 1 - Status LED
Outputs
4 Relays NO/NC contact; 1 Siren output (sink), 1 Strobe output (sink)
Input
12 Inputs
Buzzer
Beeps intermittently (in a sequence of 1 second ON, 1 second OFF) when the Installer is locating the ioXpander-
12x4 Module (in the "Find Me" Menu).
LED Status Indicators
Green: Power LED - Lights continuously when powered
Red: When the ioXpander-12x4 Module is connected, registered, and communicating with the ioXpander-8 the
red LED is off. Otherwise, it blinks every second.
Tamper Protection
Open Double Tamper front and rear, if either breaks alarm will activate.
Power Relays
SRU-S-112L (TV-5); 12 VDC, 8A or 24 VDC, 4A
RS-485 Bus
Data Rate
230Kbit/sec
Bus Backbone
26AWG (Cat 5)
DC
< 22 AWG
Bus Length
500M/1640Ft: Max.
Termination
100 Ohm Termination: The RS-485 Bus needs to be terminated at both ends with a 100 Ohm resistor
Operating
Environment
Temp: -10°C to 70°C (14°F to 159°F) Humidity: 20% to 80%, non-condensing
Physical
Weight
670 grams (23.57 ounces)
Construction
ABS plastic
Dimensions (H x W x
D)
230 x 199 x 47mm (90.625 x 7.83 x 1.84 inches)
Regulatory
EN 50131-3 Grade 2, Class II
Warranty
1-year limited warranty
Product offerings and specifications are subject to change without notice.
Important Shipment Information:
The ioXpander-12x4 Module PGM Terminal Blocks are labeled in two different ways. There is no difference in
their functionality. The only difference is how the PGM
’s PCBs are labeled.
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must contact the company from which you orignially purchased it.
If you are discarding this product and not returning it for repair then you must ensure that it is returned as identified by your supplier
.
This product is not to be thrown away with everyday waste - Directive 2002/96/EC Waste Electrical and Electronic Equipment.
