D-303503 MKP-160 User's Guide
15
Number
Indication
[1]
What it Means
PGM/X-10 control mode.
System is armed in LATCHKEY mode.
Exit beeps are shut off. This mode disables
when the exit delay is over.
[2]
System is armed in the INSTANT mode.
A message is waiting in the system.
The control panel is presently in "INSTALLER
MODE" or "USER SETTINGS".
Memory / Alarm in partition or system.
The partition / system has an active trouble
status that needs to be reviewed and cleared.
[3]
AC failure.
Communication failure: MKP-160 is out of range
of the control panel or did not get an
acknowledge signal of a command from the
control panel.
Indicates that the MKP-160 device's battery is
low and must be replaced (see section 2.1).
[1] The key indication is displayed after the first red LED blinks indicating the status request.
[2] Operates only during Exit Delay.
[3] See respective sections in the control panel's User and Installer's Guides.
[4] If there is more than one status indication at a single time, the keys are displayed
simultaneously.
Zone Status Indications
To view the zone numbers of enrolled detectors that are in NOT READY (
) or
BYPASSED state (
), repeatedly press the
key. Upon each press of the
key,
the next zone number appears on the Zone # display (marked "4"
in the "Quick Reference
Guide").
To view the zone numbers that are assigned to a Partition, press the desired Partition
number (
/
/
) followed by the
key. Upon each press of the
key, the
next zone number assigned to the pressed Partition number appears on the Zone # display.
