MENUS AND FUNCTIONS
D-307503 PowerMaster 360 User's Guide
21
B.2 Reviewing the zone bypass scheme
Here you can quickly review the bypass scheme that is the zones that are set to be bypassed when the
system is next armed.
1.
REVIEW BYPASS
Enter the [
USER SETTINGS
] menu and select the [
REVIEW BYPASS
]
1
option and press
.
2
2.
BYPASS LIST
The display reads [
BYPASS LIST
]
or
Click the
or
buttons repeatedly to review all bypassed
zones in ascending numerical order. When done, click
to exit.
9
3.
Z04: BYPASSED
Z04: P1
P2 P3
4
Kitchen
B.3 Recalling the zone bypass scheme
Use this option to repeat (recall) the most recent Bypassed Scheme for use during the next arming session.
1.
RECALL BYPASS
Enter the [
USER SETTINGS
] menu, select the [
RECALL BYPASS
]
1
option
and press
.
2, 6
2.
<OK> TO RECALL
The display now reads
[
<OK> TO RECALL
].
7
To recall the last used bypass scheme
press
.
3.
Bypass RECALLED
A "Success Tune"
☺
sounds. The display reads [
Bypass RECALLED
] and
then returns to “
USER SETTINGS
" step 1.
9
☺
Return to step 1
Additional Information (section B.1 – B.3)
1
For detailed instructions on how to select User Settings –refer to sections A.1 and A.2.
2
This menu is displayed only if "BYPASS" was previously enabled by the installer.
3
a. The STATUS to the right of the zone number indicates whether the zone is READY, NOT-READY or
BYPASSED.
b. In the example, the display reads [
Z01: READY
] alternating with [
Living Room
].
4
This display will appear only if PARTITIONING was previously enabled.
5
a. If the zone you selected is "
not bypassed
", the display prompts you to press [
<OK> TO BYPASS
]. However,
if the zone you selected is already
"bypassed"
, the display prompts you to press [
<OFF> TO CLEAR
].
b. To abort and return to the previous step press
or
6
This menu is not displayed if Partition is enabled.
7
The display now prompts you to press [
<OK> TO RECALL
] i.e. to repeat the last used bypass scheme. To
abort and return to the User Settings menu, press
.
8
You can now repeat steps 2 - 5 to bypass or clear another zone. To end this session and to select other
menu options or to quit programming - follow the instructions in section A.2.
9
You can now select another option in the User Settings menu (see section A.1), or quit programming (see
section A.2).
