SECURING THE PROTECTED SITE
10
DE5467U
Arming in the Latchkey Mode
(Not to be used in UL-listed systems)
This mode is useful for a parent at work who wants
to be sure that his children have returned from
school and have disarmed the system. Arming in the
“latchkey” mode means that a special “latchkey”
message will be sent out when the system is
disarmed by a “latchkey user”.
Latchkey users are holders of user codes 5 through
8 or users of Keyfob transmitters 5 through 8. The
latchkey message is considered an
alert
and not an
alarm, and is therefore sent to the private telephones
programmed by the user as targets for alert
messages.
Latchkey arming is possible only when you arm “AWAY”.
To arm in the Latchkey mode, proceed as follows:
PRESS RESULTANT
DISPLAY
ARMING AWAY
ARMING LATCHKEY
(Within 2 seconds)
(alternating)
PLEASE
EXIT
NOW
Vacate the premises
↓
(Exit delay)
↓
AWAY
ARM indicator
lights during the armed state.
Initiating a Panic Alarm
PRESS RESULTANT
DISPLAY
PANIC ALARM
Then, if or when the system
is in the disarmed state:
(Pressed
simultaneously)
READY HH:MM
Note:
If you are using a key-ring transmitter, press
both AWAY and HOME buttons simultaneously for 2
seconds.
To stop the alarm, press
and then key in your
valid user code.
Initiating Fire Alarm
(This function is disabled in ACPO compliant version).
PRESS RESULTANT
DISPLAY
FIRE
Then, if or when the
system is in the disarmed
state:
FIRE
EMERGENCY
READY HH:MM
To stop the alarm, press
and then key in your
valid user code.
Initiating Emergency Alarm
You can generate an emergency alarm manually
(depends on the purchased system version - see
P door label) in the disarmed and armed
states as follows:
PRESS RESULTANT
DISPLAY
EMERGENCY
Then, if or when the
system is in the disarmed
state:
EMERGENCY
FIRE
READY HH:MM
To stop the alarm, press
and then key in
your valid user code.
Disarming and Stopping Alarms
(This function is disabled in ACPO compliant version).
Disarming the system stops the siren before it stops
automatically, irrespective of whether the alarm was
initiated in the armed or the disarmed state.
After disarming, different displays may appear,
depending on the current status of the system:
A. Disarming - no events:
After an uneventful
armed term, the disarming operation will
progress as shown:
PRESS RESULTANT
DISPLAY
CODE
_ _ _
[Enter code]
READY HH:MM
ARM
indicator extinguishes
B.
Disarming after alarm, with all zones ready:
If
the zone that alarmed in the armed state is back
to normal, the disarming operation will as shown:
PRESS RESULTANT
DISPLAY
CODE
_ _ _
code
READY HH:MM
(alternating)
READY MEMORY
ARM
indicator extinguishes
To read the alarm memory, refer to Chapter 5.
The "
MEMORY
"
message
will disappear only
upon re- arming the system.
C.
Disarming after an alarm, with one zone still
disturbed:
If the zone that alarmed in the armed
state is still disturbed, the disarming operation
will progress as shown in the following table.
