USER SETTINGS
DE5467U
25
Recalling the Last Bypass Scheme
Arming the alarm system with several zones in the
bypassed state is in fact "
partial arming
". An
identical partial arming may be repeated by recalling
the last bypassing scheme (that was suspended and
memorized upon disarming the system).
Having entered your user code successfully (see
above - Entering to the User Settings Menu), the
display will read:
SET BYPASS
Click <
NEXT
> twice to change the display into:
RECALL BYPASS
At this point proceed as follows:
ACTION RESULTANT
DISPLAY
<
OK> TO RECALL
RECALL BYPASS
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
<
AWAY
>. When <
OK
>
TO EXIT
is displayed - click
<OK>.
Programming 4 Telephone Numbers
Here you determine the 1
st
, 2
nd
, 3
rd
and 4
th
telephone
numbers to which the system will report event
messages that were defined by the system installer.
You can ask the installer to set part or all the four
telephone numbers.
Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
NEXT button repeatedly (if necessary) until the
display will read:
SET PHONE NUMBER
You are allowed to program the four numbers as
follows:
PRESS RESULTANT
DISPLAY
1st private tel#
XXXXXXXXX
[Enter Tel. No.] XXXXXXXXX
XXXXXXXXX
1st private tel#
2nd private tel#
Continue the same way up to telephone number 4.
You may now switch to any other item on the USER
SETTINGS menu or quit programming by clicking
<
NEXT
> until <
OK
>
TO EXIT
is displayed and then
clicking <
OK
>.
Setting the User Codes
Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
<
NEXT
> until the display reads:
SET USER CODES
User Code 1
replaces the factory default master
user code, and should be assigned to the master
user of the system. This code can not be erased.
User Codes 2, 3
and
4
can be assigned to additional
users - family members, co-workers etc.
Codes 5 through 8
are assigned to “Latchkey
Users” (see Chapter 2 - Arming in the Latchkey
Mode, for an explanation of the latchkey mode).
CAUTION! Code “0000” is not valid! Do not use it.
Note: The duress code set by the installer (2580 by
default) cannot be selected as a normal user code.
Any attempt to program it will be rejected by the
P.
To program the codes, proceed as follows:
PRESS RESULTANT
DISPLAY
user code 1: _ _ _ _
user code1:
0
0 0 0
user code 1: 685
4
[4-digit
user code]
e.g. 6854)
user code 1: 6854
user code 2
Continue the same way up to Code 8.
user code 8: 5537
SET USER CODES
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
<
AWAY
>. When <
OK
>
TO EXIT
is displayed - click
<
OK
>.
