www.vistacnc.com
- 2 -
www.vistacnc.com
- 2 -
iMach
III
P1A Pendant LinuxCNC Manual v 1.0
PREFACE
Any machine tool, including computer controlled machine tool, is potentially dangerous. VistaCNC LLC accepts
no responsibility for any damage or injury caused by its use. It is your responsibility to ensure that you
understand the machine you are using and the procedures for safety operations.
If you are in any doubt you must seek guidance from a professionally qualified expert rather than risk injury to
yourself or to others.
Information in this document is subject to change without notice. The manufacturer does not make any
representations or warranties (implied or otherwise) regarding the accuracy and completeness of this document
and shall in no event be liable for any loss of profit or any other commercial damage, including but not limited to
special, incidental, consequential, or other damages.
WARNING
E-STOP switch button in iMach
III
P1A CNC Control Pendant only provides
Emergency STOP signal to LinuxCNC application.
For further protection in CNC operation, other emergency protection methods
may be needed.
