www.vitamobilitywerks.com
29
Warning! Failure to maintain the brushes could void the power scooter warranty.
To inspect or replace the motor brushes:
1. Unscrew the motor brush caps.
2. Remove the brushes.
3. Inspect the brushes for wear.
4. Replace the brushes if necessary.
New Motor Brush Worn Motor Brush Motor Brush caps
Inspect the state of the battery terminals every six months. Make sure that they are not corroded and
the connections are tight. Periodically apply a thin film of petroleum jelly on the surface of terminals
to guard against corrosion.
CHECKS:
l
Make sure to keep the controller clean while protecting it from rain or water. Never hose off your
power scooter or place it in direct contact with water.
l
Keep wheels free from lint, hair, sand and carpet fibers.
l
Visually inspect the tire tread. If less than 1mm (1/32”), please have your tires replaced by your
local dealer.
l
All upholstery can be washed with warm water and mild soap. Occasionally check the seat and
back for sagging, cuts and tears. Replace if necessary. Do not store your scooter in damp or
humid conditions as this will lead to mildew and rapid deterioration of the upholstery parts.
l
All moving mechanism will benefit from simple lubrication and inspection. Lubricate using
petroleum jelly or light oil. Do not use too much oil, otherwise small drips could stain and
damage carpets and furnishings etc. Always perform a general inspection of the tightness of all
nuts and bolts.
Less than 9 mm
