PAGE 15
and held until power returns. All settings
existing at the time of the power failure
will be restored when power returns.
C. SYSTEM RESET
Anytime there is reason to believe that
your spa electronic system is not operat-
ing properly, perhaps as a result of light-
ing or other interference, like your PC at
home, your spa system can be simply
reset by holding down the
“DOWN”
arrow button for 5 seconds while in the
time display mode. The system will be
reset, maintaining all the settings you had
in memory.
D. PANEL LOCK
The Selectron 100 spa panel can be
locked to keep children or others from
using any of the spa functions. To deacti-
vate all buttons, make sure
“Time”
is displayed. Use
“PROG”
button to
change to “
Time
” display if needed.
Then hold the
“UP”
arrow button for 5
seconds. Notice the flashing lock icon.
The panel is locked. To unlock the panel,
hold the
“UP”
arrow button for 5 sec-
onds again. The flashing lock icon will dis-
appear and all spa functions will be
accessible.
E. FREEZE PROTECTION
If temperature in the spa plumbing falls
below 50 degrees Fahrenheit (10
degrees Celsius) the water pump(s) will
turn on and run for at least one minute.
The display will show “ICE”. After one
minute, if the water is still below 50
degrees F (10 degrees Celsius), the
heater will turn on and raise the water
temperature 10 degrees F.
DUAL PUMP SYSTEM: L160
1. Press
“JET”
to activate the Relaxation
Therapy mode.
2. Press
“JET”
to activate pump #1
Power Therapy mode.
3. Press
“JET”
to activate pump #2
Power Therapy mode.
4 Press
“JET”
to de-activate pump #1.
5 Press
“JET”
to de-activate pump #2.
Note that for safety, all jet modes will
automatically turn off after 30 minutes.
Reactivate any therapy mode as indicat-
ed above.
C. TURNING ON THE LIGHT
Your spa is equipped with an underwater
light. Press the light button to activate
and de-activate the light. If left on, the
light will automatically turn itself off after
6 hours.
SPECIAL FEATURES
A. AUTOMATIC JETS PURGE ON 2
PUMP SYSTEMS
Once each day, at 10 AM the jet
pump(s) will automatically run for one
minute to circulate potential stale water
in the piping. This is a normal function of
the spa. The display will show
“BJ2P”
while this takes place. Note that this fea-
ture only affects 2 pump systems
(L160).
B. MEMORY
All settings that are entered into your spa
controller will be permanently retained in
its solid-state memory. In the event of a
power failure, the time will be captured
