WATER BUBBLER FILTER
INSTRUCTIONS TO FILL BUBBLER:
1.
Tilt the water bubbler attachment upside
down and fill to a level just below the
inlet tube within. This is a very small
amount of liquid.
2.
Turn the bubbler right side up and take a
breath in to draw some air through the
mouth tip to prevent leakage. The water
should be contained within the bubbler
attachment at this point.
3.
Make sure the water bubbler is dry on its
exterior by patting dry with a towel.
4.
Remove the mouth tip from the iV
vaporizer body.
5.
Wet the mouth tip o-rings with a dab of
water to lubricate the glass joint before
attaching the bubbler to the iV. Do not
force the bubbler attachment onto the
mouth tip if it does not seat easily.
Note:
If bubbler attachment is installed properly make
sure not to blow back into the water bubbler.
Doing so may cause damage to your vaporizer.
BUBBLER PROPERLY INSTALLED:
Summary of Contents for iV-1
Page 13: ...2015...
