Cautions during operation
Use fresh fruits and vegetables for juicing as they contain more juice.
Ingredients stored in the refrigerator for a long time should be soaked
in cold water for around 10 minutes before use.
Drink the fruit juice or green vegetable juice immediately after you
finish juicing. If it is exposed to air sometime, the juice will lose its taste
and natural flavor.
Do not use it for more than 30 minutes continuously.
It may cause a failure due to overheating in a motor. But, when using
continuously, stop and cool it down about 5 minutes for each use.
Do not put excessive amount of ingredients at a time.
Excessive amount with pusher usage does not operate fast juicing
Check if pulp comes out of outlet well and put small amount for use
Excessive amount of use will cause a part damage, an injury, or a failure.
Use the pusher only to press down the ingredients.
If using other object, it will get stuck in the chamber and will cause a part
damage, an injury, or a failure.
Turn off the switch while changing nozzle.
It may cause abnormal performances or a failure.
Extracted juice amount is less than before.
-Check if holes of the juice strainer are blocked.
If withered and chilled ingredients are used, it may cause blocking the strainer
holes.
If the foods are stuck on the strainer holes, please clean first and then use
again.
Frozen or refrigerated ingredients for long time are extracted into less amount
of juice.
It stops during normal operation.
-Have you put heavy loads of ingredient or thick/big ingredient?
Press reverse button for 3~5 seconds and press “ON” button again.
Repeat this process 2~3 times.
If the auger does not work even after the above process, unplug the power
cord from the socket, disassemble the drum set, wash and use it again.
A large amount of juice residue in squeezing screw does not discharge.
-Large amount of soft ingredients such as tomatoes, kiwis, strawberries, etc.
can be accumulated around the auger or feeding chute and cause a difficulty
in discharging them.
At this time, place some of fiber ingredients and push them down with pusher
for 3~4 times.
Still the problem has not been solved, unplug the power cord from the socket
and disassemble the drum set, wash and use it again.
