5
Place the bolts to connect the bottom bar
(1066) in the prepared holes, and then slide
the glass into the tracks in side bars (1065)
(5.3).
Now connect bottom bar (1066), ensuring that
the window is totally square before tighten ing
all bolts.
Position the window in the ridge bar from one
end (5.4) and (5.5) and slide it to the required
position (5.6).
Connect the window sill (1063), with the extra
bolt(s) (1001) in the glazing bar(s) (4055) (5.7)
and bolt (2001)* on the corner bar.
*For model 1300: It is recommended that the
roof vent be connected in the middle section.
In this case use bolts (1001) already placed in
the glazing bars and bolt (2001) is not required.
Bolt the window opener (1067) to the bottom
bar (1066) using screws (1006) (5.8).
Place the plastic cap (1019) over the end of
the window opener (5.6) and connect both
window fi xers (1016) onto the window sill
(1063) using screws (1006) (5.8).
6. GLAZING – CLEAR/FROSTED
GLASS
Please note the already mentioned safety pre-
cautions.
The door can be positioned in any front
section. Leave the required section free at
this point.
Press the glazing seals (1020) onto the alumi-
nium profi les (6.3) and cut to length.
On the roof begin by positioning the glass at
the ridge and fi x in place using the glazing
spring clips (1011) (6.2). The following pane
should slide under the pane directly above it
with the glass retaining clips (1012) between
the panes (6.1). If diffi culties arise in placing
the last pane, please ensure that those above
have not slipped down.
On the sides please begin from the bottom.
FINISHING
If desired, it is possible to seal the greenhouse
at the edges using silicon. Silicon is not in-
cluded.
Place the warning label inside the house.
A full range of greenhouse accessories, to help
you make the most of this product, is available
from your stockist. Please inform yourself as to
the possibilities.
SAFETY NOTICE
In the event of high wind conditions, close the
door and all vents.
In the event of heavy snowfall, clear the roof
of the building or take suitable measures to
support the roof. Heat the building in winter.
COMMENTS
For the complete protection of your new
greenhouse, we advise you to include it in
your house insurance. Please take note of
possible building rules relating to the position-
ing of greenhouses.
Please stick the included greenhouse model
label onto the door bar (1062) after success-
fully assembling this product. This information
is important in the event that replacement
parts are later required.
Please keep these Assembly Instructions in
a safe place, for future reference!
Our policy is one of continuous improvement
and we reserve the right to change the specifi -
cations without prior notice.
003.01.0905
IDA900_1300_Vitavia_003.01.0905.indd 5
26/05/2009 09:08:16
