IX.
CARE AND MAINTENANCE
OTHER CORRESPONDENCES
1
、
Temperature
Some parts of the wheelchair are susceptible to temperature changes. Keep the
wheelchair
at a temperature between 18-70ºC.
The battery can freeze in extremely low temperatures. The exact freezing point of a battery depends on many factors including
its charge, consumption and composition.
High temperatures can reduce the speed of the wheelchair. Speed reduction is a safety built into the controller to help prevent
damage to the motor and other electrical equipment.
2
、
Storage
Electric wheelchairs should be stored in a dry place, free from extreme temperatures. Disconnect the battery from the power
adapter during storage.
3
、
Cleaning instructions
Never pour water on the stroller or place it in direct contact with water.
Never use any chemicals to clean the vinyl seat as they can make the seat slippery or dry out. Use water and dry the seat
thoroughly.
4
、
When to contact the distributor.
The symptoms shown may indicate a serious problem with the wheelchair. If necessary, contact your distributor. When calling,
please provide the model number, serial number, type of problem and error code, if available.
◆
Engine noise
◆
Frayed wires
◆
Cracked or broken cables
◆
Uneven tire wear
◆
Steering problems
◆
Bent or broken wheels
◆
Unstable movement
◆
Turned on but no response
EXTERIOR SURFACES
A rubber or vinyl conditioner may be applied to bumpers, tires and upholstery from time to time.
BATTERY TERMINAL CONNECTIONS
Make sure that the terminal clamps are tight.
The batteries must lie flat in the battery compartment.
The battery terminals should face the rear of the wheelchair.
WIRE HARNESSES
Check all cable connections regularly.
Check all cable insulation regularly, including the power cord, for wear or damage.
Ask an authorized dealer to repair or replace any damaged connector, connection or insulation that you discover before re-use.
ABS PLASTIC COVER
Left and right covers should be made of durable ABS plastic and coated with an advanced formula of urethane paint. A gentle
application of car wax helps the cover maintain its high gloss.
ENGINE BRUSHES
The motor brushes are located inside the gearbox / motor unit. They should be checked periodically for wear by an authorized
dealer.
AXIAL BEARINGS AND ENGINE ASSEMBLY
There is no need to lubricate these components as they are all pre-lubricated and secured.
WARNING!
Do not use a rubber or vinyl conditioner on a vinyl stroller seat, floor board, or tire tread. They will
become dangerously slippery and cause personal injury and / or damage to the wheelchair.
2
2
