Vitek VT-1190 Manual Instruction Download

Page: 5 / 32

ENGLISH

Version 2:

–

place a suitable bowl under the spout for
pouring water (4) and press the water dis-
pense button (22) «DISPENSE».

Note: - the water is dispensed only when the
indicator (20) “ ” is switched on; if you pressed
the button (21) “UN/LOCK” and didn’t do any-
thing, the indicator (20) will go out in 10 sec-
onds.

•

To switch the thermopot off press the water
temperature selection button (23) “TEMP.SET/
KEEP WARM” and select the “ROOM TEMP”
mode, the indicator (19) “ROOM TEMP” will
light up.

•

To switch the thermopot off disconnect the
power plug (16) from the mains socket.

•

Open the thermopot lid (8) and wait until it
cools down completely.

•

Before removing the lid (8) open it and pull the
lid (8) to the control panel (5) (pic. 3).

•

Carefully tilt the thermopot to drain the
remaining water.

•

Install  the  lid  (8)  back  to  its  place.  To  do  it,
place the lid (8) at a small angle and install the
lid  (8)  to  its  installation  place.  Before  using
the  thermopot  make  sure  that  the  lid  (8)  is
fixed properly.

•

The thermopot is ready for operation.

USAGE OF THERMOPOT

•

Open the lid (8) by pressing the button (6) and
holding it (pic. 1).

•

Fill the thermopot with water using a suitable
bowl, do not exceed the maximal water level
mark (15) «FULL».

•

Insert the power cord connector (16) into the
socket  (12)  on  the  thermopot  body  and  the
power  cord  (16)  plug  into  the  mains  socket.
You  will  hear  a  sound  signal,  and  all  indica-
tors  on  the  control  panel  (5)  will  light  up  for
2  seconds.  After  that  the  thermopot  will  be
switched  on  in  the  boiling  mode,  the  indica-
tor (17) “BOILING” will glow constantly and the
indicator (18) “85°” will be flashing.

•

The keep warm temperature «85°» is set by
default.

•

After  long  water  boiling  you  will  hear  sound
signals  and  the  thermopot  will  switch  to
the  keep  warm  mode,  the  indicator  (17)
“BOILING”  will  go  out  and  the  keep  warm
mode indicator (18) «85°» will be flashing.

•

When the water in the thermopot cools down
to 85°, the indicator (18) will glow constantly
and the water temperature will be maintained.

•

If  the  water  temperature  goes  significantly
below  the  preset  temperature,  for  instance,
if  you  added  some  cold  water,  the  boiling
mode  will  be  switched  on,  the  indicator  (17)
“BOILING” will light up. After boiling the water
temperature will be maintained depending on
the  preset  value  and  will  be  shown  with  the
indicators (18).

•

To  change  the  required  keep  warm  temper-
ature  press  the  temperature  selection  but-
ton  (23)  «TEMP.SET/KEEP  WARM».  You  can
select the keep warm temperature «45°С-55°С-
65°С-85°С-95°С».

•

Recommended temperature for brewing tea
and making other beverages:

–

«45°» – water temperature for powdered
baby milk

–

«85°» – green and yellow tea

–

«95°» – black tea

•

The preset temperature is shown by the cor-
responding indicators (18).

Note:

- to reboil the water press the button (24)

“REBOIL”. The indicator (17) “BOILING” will light
up.  To  switch  the  reboiling  mode  off  press  the
button  (24)  “REBOIL”  again,  the  indicator  (17)
“BOILING”  will  go  out  and  the  thermopot  will
switch back to the keep warm mode.

•

Drain the water; to do this, you must unlock
the activation of the water pump by pressing
the button (21) «UN/LOCK», the indicator (20)
“ ” will light up.

Attention! Be careful when pouring out water to
avoid burns by hot water.

Version 1:

–

place a suitable bowl, for instance, a cup
under the spout for pouring water (4) and
press the water dispense button (3) with a rim
of the cup.

Version 2:

–

place a suitable bowl under the spout for
pouring water (4) and press the water dis-
pense button (22) «DISPENSE».

Note: - the water is dispensed only when the
indicator (20) “ ” is switched on; if you pressed
the button (21) “

UN/LOCK

” and didn’t do any-

thing, the indicator (20) will go out in 10 seconds.

IM VT-1190.indd 5