3
ENGLISH
THERMOPOT VT-1197
An electric thermopot is intended for boiling water
and maintaining the required temperature of water.
DESCRIPTION
1.
Minimal water level mark «МИН»
2.
Water level scale
3.
Water dispense ON-button
4.
Spout for pouring water
5.
Control panel
6.
Lid opening button
7.
Steam release openings
8.
Removable upper lid
9.
Lid lock
10.
Carrying handle
11.
Body
12.
Power cord connector
13.
Rotary base
14.
Sealing gasket
15.
Maximal water level mark «МАКС»
16.
Power cord
17.
Hand pump mechanical lock «Lock/UN Lock»
18.
Hand pump
Control panel
19.
Water boiling mode indicator “BOILING”
20.
Water temperature selection button
“TEMP.SET”
21.
Keep warm mode indicator “KEEP WARM”
22.
Reboil button “REBOIL”
23.
Indicator “TEMP DECLINING”
24.
Keep warm mode indicators “45°-85°-95°”
25.
Water dispense button «DISPENSE»
26.
26. Unlocked water dispensing indicator “ ”
27.
Water dispensing unlock button “UN/LOCK”
ATTENTION!
For additional protection it is reasonable to install a
residual current device (RCD) with nominal opera-
tion current not exceeding 30 mA, to install RCD,
contact a specialist.
SAFETY MEASURES
•
Before using the electric thermopot, read this
instruction manual carefully.
•
Make sure that the operating voltage of the unit
corresponds to the voltage of your mains.
•
The power cord is equipped with a «euro plug»;
plug it into the socket with reliable grounding
contact.
•
To avoid fire, do not use adapters for plugging
the unit in.
•
Do not connect or disconnect the power cord
with wet hands, this may cause electric shock
or injuries.
•
When unplugging the unit, always pull the plug
but not the cord.
•
Never leave the operating unit unattended.
•
Do not switch the thermopot on if it is empty.
•
Do not drop or tilt the unit.
•
Use the thermopot only for water boiling; it is
prohibited to heat or boil other liquids in it.
•
Ensure that water level in the thermopot is
not below the «МИН» mark and not above the
«МАКС» mark.
•
Do not fill the thermopot with water directly
from the faucet; to fill the thermopot use a suit-
able bowl.
•
Place the thermopot on a flat dry and stable
surface; do not place the thermopot on the
edge of the table.
•
Do not place the thermopot next to the walls or
close to the kitchen furniture. Place the ther-
mopot keeping at least 20 cm gap between the
thermopot body and the wall or furniture and at
least 30 cm gap above the thermopot.
•
Do not use the unit near heat sources or open
fire.
•
Do not let the power cord hang from the edge of
the table and make sure it does not touch hot or
sharp edges of furniture.
•
Do not open the lid and do not pour water out
during boiling.
•
Do not rotate the unit during water pouring.
•
Do not apply excessive effort when closing the
lid. When using the thermopot, make sure that
the lid is closed tightly.
•
Keep your hands away and do not bend over
the steam release openings, it may cause
burns. Do not block the steam release opening
with any objects.
•
Do not touch hot surfaces of the thermopot.
•
Be careful while carrying the thermopot filled
with boiling water.
•
Do not carry the thermopot holding it by the lid
opening button.
•
Be careful when pouring out hot water.
•
Remove the lid before draining the remaining
hot water from the thermopot flask.
•
To avoid risk of electric shock, do not immerse
the thermopot, the power cord and the power
plug of the unit into water or other liquids.
•
Unplug the unit, if you are not using it or before
cleaning.
IM VT-1197.indd 3
01.08.2018 17:13:30
