3
ENGLISH
APPLIANCE FOR HEATING LIQUIDS VT-1198 ST
The appliance for heating liquids (thermopot) is
intended for boiling water only. For proper and
safe use of the unit read these instructions care-
fully.
DESCRIPTION
1.
Low water level mark «MIN»
2.
Illuminated water level scale
3.
Lower water dispensing button
4.
Spout for water pouring
5.
Display
6.
Control panel
7.
Upper water dispensing button
8.
Lid opening button
9.
Steam release openings
10.
Lock
11.
Removable upper lid
12.
Carrying handle
13.
Lid axis
14.
Maximal water level mark «FULL»
15.
Body
16.
Power cord connection socket
17.
Power cord
18.
Rotary base
Control panel
19.
Water boiling/re-boiling ON-button «Boil/Stop»
20.
Heating temperature selection button
«Temperature selection»
21.
Water boiling mode/temperature mainte-
nance mode indicator
22.
Power saving mode indicator
23.
Light sensor
24.
Unlocked water dispensing indicator
25.
Delayed start button «Delayed start»
26.
Water dispensing lock/unlock button
«Unlock»
Display
27.
Water temperature indication
28.
Delayed start time indication
29.
Set water temperature indication
ATTENTION!
For additional protection it is reasonable to install
a residual current device (RCD) with nominal
operation current not exceeding 30 mA, to install
RCD, contact a specialist.
SAFETY MEASURES
Before using the thermopot, read this instruction
manual carefully and keep it for future reference.
Use the unit for intended purposes only, as speci-
fied in this instruction manual. Mishandling the
unit can lead to its breakage and cause harm to
the user or damage to his/her property.
•
Make sure that the operating voltage of the
unit corresponds to the voltage of your mains.
•
The power cord is equipped with a «euro-
plug»; plug it into the socket with a reliable
grounding contact.
•
To avoid the risk of electric shock, do not use
adapters for connecting the unit to the mains.
•
Do not use the unit in bathrooms. Do not use
it near swimming pools or other containers
filled with water.
•
Do not use the thermopot near heat sources
or open flame.
•
Place the thermopot on a flat stable surface;
do not place the unit on the edge of the table.
•
Do not place the unit near walls or furniture,
the distance between the unit and any other
surface should be at least 30 cm.
•
Do not use the unit outdoors.
•
Do not connect or disconnect the power cord
with wet hands, this may cause electric shock
or injuries.
•
Make sure that the power cord does not hang
from the edge of the table or touch hot sur-
faces.
•
When unplugging the unit, pull the plug but
not the cord.
•
Do not switch the unit on without water.
•
Use the thermopot only for water boiling; it
is prohibited to heat or boil other liquids in it.
•
Ensure that the water level is not below the
minimal mark and not above the maximal
mark.
•
Do not refill the thermopot during boiling or
right after it.
•
Do not fill the thermopot with water directly
from the faucet; to fill the thermopot use a
suitable bowl.
•
Do not drop, overturn or tilt the unit.
•
Do not leave the operating unit unattended.
•
Do not open the lid and do not dispense water
during boiling.
•
Do not rotate the unit from side to side when
turning water dispensing on.
•
Close the lid properly, but without excessive
effort.
•
Keep your hands away from steam release
openings and do not bend over them, it may
cause scalding. Do not block the steam
release openings with any foreign objects.
VT-1198.indd 3
18.09.2015 12:56:38
Summary of Contents for VT-1198 ST
