ENGLISH
6
upper lever position, haircut will
be the shortest one. In the down
lever position the cutting length
is approximately the same as with
the 3 mm attachment comb (6)
usage. Changing the position of
the lever while cutting hair, you
can select the necessary length
of the hair to cut.
–
If hair is jammed in the blades (3,
4) while cutting, move the lever
(2) from the upper position to the
down position several times, so
you can release the jammed hair
without removing the blades.
–
When the hair clipper is switched
on, move the lever several times
from the upper position to the lower
position, this way you can remove
the cut-off hair from the blades.
–
If the unit pulls hair while cutting,
it means that the blades (3, 4)
became blunt, replace them with
new ones.
Instructions on hair cutting
•
Hair should be clean and dry while
cutting.
•
Insert the power plug into the
mains socket.
•
Before cutting hair, switch the unit
on by moving the power switch (1)
to the position «ON» and make
sure that the hair clipper operates
normally and the blades move
smoothly. If there is excess oil
on the blades, remove it with a
dry cloth.
•
Constantly check the power cord,
prevent it from multiple twisting,
regularly switch the unit off and
straighten the power cord.
•
Seat the person so that his/her
head is approximately at your eye
level, cover the person’s shoul-
ders with a towel and set hair with
the comb (11).
Attention:
–
Always cut off a little amount of
hair at a time. If necessary you
can always return to the trimmed
area for additional cutting.
–
The best haircutting results
are reached on dry hair, not wet.
–
Set the hair with the comb (11) to
reveal uneven locks.
–
It is better to leave longer hair
after cutting for the first time.
–
After learning your clipper better,
you will be able to arrange your
hair in any style you need.
Attachment combs
The length of hair depends on the
attachment comb:
–
Attachment comb (6): hair length
3 mm
–
Attachment comb (7): hair length
6 mm
–
Attachment comb (8): hair length
9 mm
–
Attachment comb (9): hair length
12 mm
Set the attachment upper part on the
blade and press it until click. To remove
the attachment comb, press the clamp
and remove the attachment.
Step one
Set the 3 mm attachment comb (6) or
6 mm attachment comb (7). Switch
the unit on using the power switch (1),
setting it to position «ON». Hold the
VT-2516_100�140.indd 6
09.03.2016 14:51:39
