8
ENGLISH
Step one
Set the 3 mm attachment comb (5) or 6 mm attachment comb
(6). Switch the unit on using the power switch (4), setting it
to position «I». Hold the hair clipper with the blades pointed
upwards. Start cutting from the beginning of the hair growth.
Slowly move the trimmer upwards. This way cut the head back
area at neck bottom and near the ears (pic. 3, 4, 5).
Step two
Switch the hair clipper off with the power switch (4) by
setting it to the position «O», unplug the unit, then set
the 9 mm attachment comb (7) for longer hair or 12 mm
attachment comb (8) and continue cutting hair near top of
the head (pic. 6).
Step 3 – cutting in the temples area
Switch the hair clipper off and unplug it, then set the 3 mm
attachment comb (5) or 6 mm attachment comb (6) and cut
hair in the area of temples. Then set the 9 mm attachment
comb (7) or 12 mm attachment comb (8) and continue cut-
ting towards the top of the head (pic. 5).
Step 4 – cutting the crown of the head
Using the 9 mm attachment comb (7) or 12 mm attachment
comb (8), cut the hair on the top of the head towards the
crown against the hair growth direction (pic. 6).
•
You can cut hair against and along the direction of hair
growth, but keep in mind that the hair cut against the
growth will be shorter than the hair cut along the growth.
•
Use the 3 mm attachment comb (5) and 6 mm attach-
ment comb (6) for very short haircut. To leave a little lon-
ger hair, use the 9 mm attachment comb (7) or 12 mm
attachment comb (8).
•
To leave longer hair, grip hair locks between
your fingers and cut the hair off using the clipper (pic. 7).
•
You can use the comb: lift the hair locks and cut them
with the hair clipper above the comb (9) (pic. 8).
•
Always start cutting from the head back.
•
Comb (9) the hair to reveal uneven locks.
•
Use scissors (10) to trim hair.
