Vitek VT-6406, Manual Instruction

ENGLISH

5

4.   Do not apply hard efforts to the units, do not subjects the units to strikes (dust and 

moisture are also 

contraindicated

), as it can lead to failures and correspondingly to 

the reduction of life time, damages of the batteries and to the deformation of the body 
details.

5.   Do not dismantle the unit; it will lead to the ending of guarantee. There are no details, 

demanding attention of the user inside it. 

6.   Use only new and specified in the manual batteries. 

7.   Use the net adapter supplied. 

Connecting the net adapter to the base unit/placing batteries into the remote con-
trol and remote sensor: 

Connecting the net adapter to the base unit

1. Make sure that the adapter voltage corresponds to the voltage in the mains. 

2. 

Using the external power supply jack, connect the net adapter to the base unit supplied 

(5.0

V DC)

.

Placing batteries in the remote sensor

1.  Unscrew the screws on the battery compartment lid.
2.  Insert 2 batteries of AAA type, following the polarity.
3.  Close the battery compartment lid and tighten up the screws.

Placing batteries in the remote control

The remote control is supplied with the batteries CR 2025 inserted. To activate the remote 
control pull out the insulating insert.
To replace the battery follow the instructions on the rear panel.  Follow the polarity when 
replacing the batteries.

Note: 

While long operation of the sensor in the conditions of extreme temperatures, 

the 

voltage of its batteries can be lowered, the operation radius of the remote sensor will be 
reduced.

Synchronization of operation of the basic unit and the remote sensor    

As soon as the power adapter is connected to the base unit, it will start signal searching 
from the remote sensor during 4 minutes. Before it, you should open the battery compart-
ment lid; select the data transfer channel, insert batteries in the remote sensor. After the 
batteries in the remote sensor are inserted, it will start transfer of data, which will appear 
on the display of the base unit.
During signal searching by the base unit, press the 

TX

 button inside the battery compart-

ment of the remote sensor for quicker data transfer.
After the data from the remote sensor are received, they will appear on the display of the 
base unit.
To find channels from the remote sensor you can do the following procedure.
Enter the main menu, by pressing the 9 

Exit

 button of the base unit or the 7 

MENU

 button 

on the remote control. Use the 

►/◄

 buttons to select the 

Settings

 mode. Press 

ENTER

to confirm the mode. Use the 

▼

 button to select the 

Receipt from external sensor

 item. 

Use the 

►/◄

 buttons to select 

Search

, press 

Enter

 to confirm the parameters.  The base 

6406_IM.indd   5

6406_IM.indd   5

12.03.2010   10:19:41

12.03.2010   10:19:41