6
ENGLISH
–
Once the operating surface (2) reaches the set tempera-
ture, the flashing temperature symbols on the indication
panel (5) will glow constantly.
–
Take a hair lock with the free hand.
–
Press the clamp handle (4), place the end of the lock on
the operating surface (2) and move the clamp (4) down.
Holding onto the protecting tip (1) and handle (8), wind the
lock around the operating surface (2).
–
Wait for a while, then press the clamp handle (4) and
release the hair lock.
–
Repeat this procedure on the rest of your hair.
Notes:
–
during the first operation some foreign smell and a small
amount of smoke from the heating element is possible,
it is normal.
–
do not touch the operating surface (2) during the unit
operation, hold the unit by the protecting tip (1) with one
hand and by the handle with the other (8).
–
during breaks in operation, place the unit on the safety
stand (3) on a flat heat-resistant surface.
–
do not comb the hair right after curling it, let it cool down,
divide big locks into smaller ones carefully to make the
hairstyle look natural.
–
After you finish using the unit, switch the unit off by press-
ing and holding the button (7), the temperature symbols
on the indication panel (5) will go out, then unplug the unit.
Note:
If the temperature setting buttons (6) «-/+» are not
pressed within 60 minutes, the curling tongs will be switched
off automatically.
Put the unit on the safety stand (3) on a flat heat-resistant
surface and let it cool down completely.
CLEANING AND CARE
–
Before cleaning unplug the unit and let it cool down com-
pletely.
–
Do not immerse the unit, power cord and power plug of
the unit into water or any other liquids.
–
Do not use detergents, abrasives or any solvents to clean
the unit.
–
Clean the unit body with a soft, slightly damp cloth and
then wipe it dry.
STORAGE
–
Let the unit cool down completely and clean it before tak-
ing away for storage.
–
Never wind the cord around the unit body, as this can
damage the cord.
IM VT-8422.indd 6
28.07.2017 11:22:31
