System Setting
34
5.
Press the [EXIT] button on the remote control or right-
click any area to display the popup window as in the
right picture.
6.
while the popup window is displayed, select
<Sensitivity> to set the motion detection sensitivity of
the channel currently selected.
i
Channel: Select the channel to set the motion
sensitivity.
-
SEnSITIVITy : 1(Low) ~ 30(High) - The higher
the number is, the higher the sensitivity level
becomes.
i
DAyTIME : specify the time period that will be
considered as daytime.
-
DAyTIME : specify the <SEnSITIVITy> for the daytime.
-
nIGHTTIME : specify the <SEnSITIVITy> for the nighttime.
Images recorded in a low contrast scene such as at night can cause severe noise, which can trigger motion events too often.
If unwanted events occur frequently at night, you may want to reduce the motion sensitivity for the nighttime setting.
\
\
PTZ Settings
Set the camera ID, protocol, baud rate, and PTZ control speed for each channel.
1.
From <SySTEM SETUP> - <CAMERA>, select <PTZ SETUP>.
2.
Use [
▲▼◀▶
/EnTER] buttons of the remote control or
mouse to set protocol and baud rate of each channel.
Refer to the camera's manual or consult your installation
technician for further information about your PTZ camera.
3.
To apply your changes, click the <APPLy> button.
4.
Once the setup has been completed, press the [EXIT]
button of the remote control or click <CLOSE> button
on the bottom. Click <CAnCEL> to return to the
previous menu.
