54
FREQUENTLY ASKED QUESTION/ TROUBLESHOOTING
Question/problem - cause
Cause
Solution
The engine does not start:
•
Throttle handle is not being pressed;
•
The tank is out of fuel;
Fuel line clogged;
The fuel tap is closed;
•
The fuel in the tank is of poor quality, is dirty or is
already old;
•
Spark plug cap is removed from the spark plug;
•
Spark plug has soot or is damaged;
Improper gap between electrodes;
•
The air filter is dirty;
•
The combustion engine is " wet " due to various
attempts to start it;
•
Combustion engine oil level too low;
•
Press the throttle handle;
•
Refuel;
Clean fuel lines and open the tap;
Open the fuel tap;
•
Use new fuel (petrol),
Clean carburetor;
•
Fit the spark plug cap into the spark plug;
•
Clean/replace the spark plug;
Adjust the gap between electrodes;
•
Clean/ replace air filter;
•
Unscrew the spark plug and dry it, push the throttle
hand and pull the starter handle several times with
the spark plug unscrewed;
•
Refuel with engine oil;
Difficult start-up or combustion engine power
decreases:
•
Presence of water in the fuel tank;
The carburetor is clogged;
•
The fuel tank is dirty;
•
The air filter is dirty;
•
The spark plug is sooty;
•
Empty the fuel tank;
Clean fuel lines;
•
Clean the fuel tank;
•
Clean/ replace air filter;
•
Clean/replace the spark plug;
The engine runs irregularly:
•
The air filter is dirty;
•
Clean/ replace air filter;
The combustion engine overheats:
•
Ventilation slots are dirty;
•
Combustion engine oil level too low;
•
The surface of the combustion engine is covered
by dirt;
•
Clean the ventilation slots;
•
Refuel with engine oil;
•
Remove dirt from the combustion engine;
The tiller blows too much smoke:
•
The oil level is too high;
•
The air filter is dirty;
•
Adjust oil volume;
•
Clean/ replace air filter;
Strong vibration while operating:
•
Loose engine housing;
•
Screw the engine fixing screws;
Low performance:
•
The tines are incorrectly assembled;
•
The tines are worn;
•
Depth gauge is incorrectly set;
•
Assemble the tines incorrectly;
•
Replace tines;
•
Adjust depth gauge;
The tines do not rotate:
•
Tines are not fixed to the drive shaft;
•
Check the tines’ fixing to th
e drive shaft;
Summary of Contents for VIMETD7
Page 39: ...39 EQUIPMENT DESCRIPTION AND PACKAGING CONTENT PETROL TILLER DIRECT TRANSMISSION VIMETD7 ...
Page 74: ......
Page 75: ......
Page 76: ...VIMETD7_REV02_DEZ20 ...
