27
FREQUENTLY ASKED QUESTIONS/ TROUBLESHOOTING
Question/Problem - Cause
Cause
Solution
The appliance does not switch on:
•
The compressor is switched off;
•
Leaks in the compressed air supply system;
•
Switch on the compressor;
•
Repair compressed air supply system;
The appliance runs irregularly:
•
The air inlet filter is clogged;
•
Clean or change the air inlet filter;
The impact wrench does not tighten the bolt properly:
•
Low compression;
•
Increase pressure. Do not exceed the maximum allowable
operating pressure;
The impact wrench does not loosen the bolt properly:
•
Too low torque;
•
Rusted bolt
;
•
Turn the torque control knob to a higher setting;
•
Use an anti-corrosion product;
WARRANTY CERTIFICATE
The warranty of this pneumatic impact wrench is two years
from the date of purchase. You should, therefore, keep your
proof of purchase during this period. The warranty covers any
manufacturing defect in material or operation, as well as parts
and work needed for their recovery.
Excluded from the warranty are the misuse of the product, any
repairs carried out by unauthorized individuals (outside the
service center of the brand VITO) as well as any damage caused
by the use of it.
DECLARATION OF CONFORMITY
We declare, under our sole responsibility, that the product
labelled 1/2” SET PNEUMATIC IMPACT WRENCH with code
VIKCIP12 complies with the following standards or normative
documents:
EN 11148-3:2012
, AfPS GS 2014:01 PAK, as defined
by:
2006/42/EC
- The Machinery Directive
S. João de Ver,
30th june 2021
Central Lobão S. A.
Technical supervisor
Hugo Santos
Summary of Contents for PRO POWER VIKCIP12
