The polisher was conceived to operate over a long period of
time with a minimum of maintenance. For a continuous and
trouble-free operation, you must perform regular cleaning
and proper maintenance tasks.
Before inspecting, performing any maintenance or
cleaning, turn off the polisher and unplug the power cord.
The motor will not start when the carbon brushes are worn
out. The carbon brushes must be replaced in good time,
otherwise there will be faulty contact between the carbon
brushes and the rotor, which may cause sparks and
damage the polisher. Both carbon brushes must be
replaced at the same time by two carbon brushes with the
same characteristics.
1.
Loosen the fixing screws and remove the carbon brush
caps (12);
2.
Lift the spring clip and remove the carbon brushes by
disconnecting the copper wire;
3.
Insert the carbon brushes on the holder, connect the
copper wire and then place the spring clip over the
carbon brush;
4.
Place the caps back on and fasten the screws.
Cleaning
After each use, clean all the components of the polisher.
Wipe the power tool with a clean, damp cloth or blow it with
low pressure compressed air.
Wash the polishing pads for good results. After each use,
wash the pads with warm water and soap. Never use
solvents.
Careful handling protects the power tool and extends its
service life.
The power tool and its ventilation slots must be kept clean.
Clean the ventilation slots regularly or whenever they
become blocked.
Storage
When not in use, store the polisher in a dry, clean place,
free of corrosive smoke and out of children’s reach.
The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of power tools with your household
waste!
According to the European Directive 2012/19/EC on
electrical and electronic equipment waste and its
transposition into national law, power tools must be
collected separately and delivered to the collection sites
provided for this purpose.
You can get information regarding the disposal of the power
tool through the person in charge for recycling in your city.
Tel.:
+351 256 248 826
E-mail:
Website:
www.centrallobao.pt
Summary of Contents for PRO POWER VIP1200A
