95x Series Operating Manual - May 17, 2022
Page
65
of
155
Delay: 2.00sec
Allow for dielectric storage in the panel
End On: FAIL
As required
Lim: 100.0M-no max
As required
ARC DETECT:OFF
As required
DISCHARGE: NONE
No need to discharge before the next step, reduces test time
ON FAIL: ABORT SEQ
Optional, could continue testing if fails
Seq 1 Step 2 DCW
Different breakdown and leakage limits, so use DCW
LEVEL: 2500.0V
As required
BREAKDOWN: 20.00mApk
Must be greater than the charging current
RAMP: 1.00sec
As required
DWELL: 5.00sec
As required
Delay: 1.00sec
Allow for dielectric storage in the panel
Lim: 0n-1.000mA
As required
ARC DETECT:OFF
As required
DISCHARGE: FAST
ON FAIL: ABORT SEQ
Example 4
–
In example 3 above, it is required to ensure that the panel is connected to the 95x during the tests. Since the panel
has very little DC leakage but has significant capacitance, this is easily achieved by adding a low voltage AC test at
the start of the sequence. Since the load has a minimum capacitance of 1uF and a maximum of 4uF, the current at
10V/20Hz will be between 1.25 and 5mArms. This requires that the Opt.AC-2 option be installed.
This is accomplished in three steps as follows
–
Seq 1 Step 1 ACez
Simple RMS min and breakdown, so use ACez
LEVEL: 10.0V 20.0Hz
As required
RAMP: 0.02sec
Use a fast time to reduce test time
DWELL: 0.10sec
Use a fast time to reduce test time
Lim: 1.000m-5.000mA
As required
ON FAIL: ABORT SEQ
No need for further tests if fails
Seq 1 Step 2 DCIR
This could also be a DCW test with the same results
LEVEL: 500.0V
As required
BREAKDOWN: 5.000mApk
Must be greater than the charging current
RAMP: 1.00sec
As required
DWELL: 5.00sec
As required
Delay: 2.00sec
Allow for dielectric storage in the panel
End On: FAIL
As required
Lim: 100.0M-no max
As required
ARC DETECT:OFF
As required
DISCHARGE: NONE
No need to discharge before the next step, reduces test time
ON FAIL: ABORT SEQ
Optional, could continue testing if fails
Seq 1 Step 3 DCW
Different breakdown and leakage limits, so use DCW
LEVEL: 2500.0V
As required
BREAKDOWN: 20.00mApk
Must be greater than the charging current
RAMP: 1.00sec
As required
DWELL: 5.00sec
As required
