36
2801/2802 Power Analyzer User Guide
Single-Channel Measurements of a Load:
Connection Method 1
Wiring Loss
Wiring Loss
V
A
Source
Load
+
-
+
-
W
2
ohms
W
1
ohms
Optional
Line Switch
Figure 13. Measuring a Load, Method 1
Configure the channel as follows -
•
This connection method is suitable for most applications.
•
At high frequencies, the wiring length between the load and the
current and voltage measurement points should be kept as short as
possible to avoid inductive and capacitive losses causing inaccuracies.
•
Optionally, set
Wiring Impedance
to (W1 + W2) ohms. The
instrument will always automatically adjust for the internal shunt
burden resistance if the channel is set to use the internal shunt. Other
than the internal shunt burden, include all wiring resistances between
the load and the points at which the voltage is measured in the entered
value for wiring impedance.
•
Set
V Burden Compensation
to
NO
.
•
If the current measurement terminals are reversed, then set
Reverse
Current
to
YES
, otherwise set to
NO
.
•
If the voltage measurement terminals are reversed, then set
Reverse
Voltage
to
YES
, otherwise set to
NO
.
Summary of Contents for Xitron 2801
