Configuration Setup
51
Rectify—
Rectify
in the menu means the average rectified amplitude (or mean modulus) of the
selected input.
Form Factor—
FF
in the menu means form factor of the selected input, such as, the ratio of the
average rectified and true RMS amplitudes.
Crest Factor—
CF
in the menu means the crest factor of the selected input, such as, the ratio of the
peak and true RMS amplitudes.
Highest Peak—
High Pk
In the menu means the highest detected peak amplitude of the selected
input, such as the most positive.
Lowest Peak—
Low Pk
in the menu means the lowest detected peak amplitude of the selected input,
such as the most negative.
Peak—
Peak
represents the highest detected peak amplitude of the selected input, such as
either the most positive or the most negative.
Pk-Pk
—
This is the difference between the highest and lowest detected peak amplitudes of the
selected input.
THD-Fund
—
This is the total harmonic distortion of the selected input, relative to the fundamental
component—You may select the maximum harmonic to be included.
THD-Harm
—
This is the total harmonic distortion of the selected input, relative to the total
harmonic content—You may select the maximum harmonic to be included.
THD-Sig
—
This is the total harmonic distortion of the selected input, relative to the total RMS
signal content—You may select the maximum harmonic to be included.
Frequency
—
This is the fundamental frequency of the selected input, or the fundamental
frequency selected as sync. for amplitude measurements.
Summary of Contents for Xitron 6000-2
