28
6000-2 & -3 User Guide, Rev E
The default
Nullmeter Scaling
screen is:
NULLMETER SCALING
0 to 1 = + 180.000
Bar Lin Centered
The default
Setup Measurements
are as follows:
Fundamental Frequency
Fund:
Measured
Fundamental Frequency Range
Fund:
40.0 – 500 Hz
Fundamental Source
From:
AB
Nom Amplitude Measurement Period
Min Period
0.250S
Filter frequency
Filter
50.0kHz
Maximum Harmonics
Max Harmonics:
200
Fundamental Bandwidth
Fundamental
÷
BW:
2
Analysis
FFT Type:
Normal
Fundamental Frequency Averaging
Sync Averaging:
med
Fundamental Frequency Measured Period
Sync Period:
0.250S
Ø
To abort a displayed menu and discard any changes:
•
Press the
CLEAR
key to abandon any change made and restart the selection from
the beginning. Note that the cursor remains in the item being changed.
—Or—
•
Select an all-uppercase “heading line” and press the
DISPLAY SELECT 1
key.
Press a new
DISPLAY SELECT
key.
Ø
To change a display line:
1. Within the Results Data display, press the
DISPLAY SELECT
key next to the line
to be changed. Use the
é
and
ê
keys to scroll up and down to the various lines.
Note that the topmost line is #00.
2. The display will show the present measurement details/configuration for that
Results Data line. Press the
DISPLAY SELECT 1
key repetitively, to change the
Parameter Type for the display data.
•
With this menu line, you may select: a single parameter; a deviation between
two parameters, such as a parameter and constant; or various “special” data.
•
The menu line corresponding to
DISPLAY SELECT 2
key, indicates the
primary (p) parameter for that Results Data display line and it may give the
bandwidth, harmonic, or harmonic range that applies to the primary
parameter.
Summary of Contents for Xitron 6000-2
