ASTRO 720W CUTTER
Owner’s Safety and Operating Manual
1. Motor Base Unit
2. Cutting Surface
3. Power Switch
4. Splash Guard
5. Cutting Blade
6. Angle Guide
7. Cutting Guide
8. Cutting Guide Adjustment Knobs
9. Mitre Adjustment Knobs
10. Water Reservoir
11. Spanner
4
• Always clean sludge thoroughly from tray after use.
• Wash with a clean damp cloth. Do not use a water jet or hose.
• Keep the cutter free from oil and grease and store in dry conditions.
• No regular servicing is required. In the unlikely event of operating difficulty, please contact
Vitrex directly.
• Use the diamond blade with continuous rim for cutting tiles.
• Use the turbo disc to cut: bricks, concrete tiles, flat tiles, roof tiles and thin concrete.
• Visit www.vitrex.com for 200mm replacement blades for this cutter.
ANGLE GUIDE
• The angle guide fits on top of the cutting guide.
• Use the adjusting knob to set the guide to the required angle
(Fig 6).
WATER RESERVOIR
• Fill the reservoir with water to a depth of 20mm.
• Ensure the water level continues to cover the blade whilst
cutting.
• Top up the water level between cuts if required.
CUTTING A MITRE
• Unscrew the round knobs both sides of the machine body to
release the table from the flat position.
• Lift up the left side of the table and use the angle guide
measure to set the table top at the desired position.
• Tighten the round knobs to secure the table in place. (Fig 7)
For after sales care or any other additional questions you may have regarding Vitrex
tiling tool product range, please contact us on 01335 347300.
CARE AND CLEANING
CUTTING BLADES
Fig. 6
Fig. 7