IT
5
dei cavi della presa sia idonea alla potenza assorbita dall’apparecchio.
5.
AVVIAMENTO
All’atto dell’installazione l’Ice Maker realizza un primo ciclo a vuoto ed i successivi
cicli con produzione di ghiaccio. Lo scarico dei primi cubetti avviene dopo circa 1
ora.
5.1. AVVIAMENTO MODELLO “REFILL”
Aprire la porta, estrarre la vaschetta contenimento ghiaccio, versare acqua potabile
attraverso il bocchettone nel serbatoio (K) (min.1 litro / max.5 litri) (vedi fig.1),
verificando il livello acqua dall’apposita finestra (H). Eseguire questa operazione
lentamente per evitare la fuoriuscita dell’acqua. Inserire la spina nella presa
di corrente, accendere l’interruttore (A) e posizionare la manopola in modalità
“Produzione ghiaccio“.
ATTENZIONE: Riempire il serbatoio utilizzando esclusivamente acqua
potabile.
5.2. AVVIAMENTO MODELLO “HYDRO”
Collegare la rete idrica al bocchettone filettato (4) presente sull’elettrovalvola (E)
mediante l’apposito tubo flessibile (3) in dotazione (vedi fig. 4). L’apparecchio
è previsto per il funzionamento con pressione idrica compresa fra 1 e 3 bar.
Assicurarsi che la rete idrica fornisca acqua potabile e che la pressione sia
tale da ottenere una produzione di ghiaccio per ciclo compresa fra 120/135 gr
(pressione ottimale 2 bar). E’ consigliato l’utilizzo di un rubinetto sulla linea
idrica. È possibile variare leggermente la dimensione delle mezze lune al fine di
ottenere una produzione di ghiaccio per ciclo corretta. A tal fine leggere il capitolo
“REGOLAZIONE FINE INGRESSO ACQUA”. Inserire la spina nella presa di corrente,
accendere l’interruttore (A) e posizionare la manopola in modalità “Produzione
ghiaccio“.
6.
REGOLAZIONE “FINE” INGRESSO ACQUA
Agendo con un cacciavite sulla vite di regolazione del livello acqua (vedi fig. 1) si
sposta il contatto direttamente sulla cubettiera.
− Girando la vite in senso orario
diminuisce la quantità di acqua
− Girando la vite in senso antiorario
aumenta la quantità di acqua
Una rotazione completa (360°) produce un riempimento di 40 cm³ di acqua (~2.4
sec.). Una mezza rotazione (180°) produce un riempimento di 20 cm³ di acqua
(~1.2 sec.)
7.
UTILIZZO DELL’ICE MAKER
Il fabbricatore ha due modalità di funzionamento:
• Modalità produzione ghiaccio nella quale il fabbricatore produce le mezze lune di
ghiaccio
• Modalità mantenimento nella quale il fabbricatore non produce le mezze lune di
ghiaccio e conserva quelle prodotte.
Summary of Contents for ICE Maker
