EN
EN
7.2.
“HYDRO” MODEL START
-UP
Connect the flexible hose provided on the solenoid valve (F) through the
appropriate threaded union, to the water supply. The appliance is intended for
operation with water pressure of between 1 and 3 bar. Make sure that the water
network supplies drinking water and that the pressure is such as to obtain
correct ice production for each discharge cycle (on 100g for 12 cubes, optimal
pressure 2 bar). The use of a tap on the water line is recommended. Start the
machine by keeping the start button D1 pressed for a few seconds (see fig.5).
8.
USING THE ICE MAKER
The ice maker has two operating modes:
•
Ice production
mode in which the ice maker produces crescents of ice
•
FREEZER
mode in which the ice maker does not produce crescents of ice but
can be used as a freezer.
8.1
ICE PRODUCTION MODE
During the production of ice, the "production (D2)" command must be active
(LED on) (see fig. 5). The production cycle proceeds as follows:
−
PRODUCTION
When the pre-set temperature is reached, the cycle of ejection of the ice from
the ice cube tray (A) begins (the proejection cycle can last from 25 to
30 min.*).
−
EJECTION
1
Once at temperature, the thermostat activates the resistance
and the motor.
2
The extracting blades will press on the ice until it detaches; the
resistance is always active.
3
The blades extract the ice cubes from their seats, pouring them
into the tray (C) and refilling with new water.
The ice production cycle continues until the ice collection tray is filled (C) (or
when the water in the tank L runs out) entering the product ice maintaining
mode (light D2 flashing).
The base of the ice cube tray is filled with
water through a water supply or tank.
