6.
TECHNICAL CHARACTERISTICS AND
OVERALL DIMENSIONS
The rating label shows the main technical data, while the dimensions
oftherefrigeratorandboxingareshowninTable3
.
7.
CLEANING AND MAINTENANCE
Safety Standards
All cleaning and maintenance must be carried out when the refrigerator
has been disconnected from all power supplies.
All cleaning and maintenance must always be carried out by previously
trained personnel who have read and understood all of the prescriptions
for safety contained in this manual and who aware of possible residual
risks.
Always adhere to the time periods specified by the manufacturer.
During all cleaning and maintenance operations, always use individual
protection devices (with CE marking) to protect against possible injuries to
hands
Do not use abrasive products, detergents or soap to clean the appliance.
16
Maintenance – Cleaning Schedule
Any operations not included in Table 1 are to be considered as repairs
and for this reason, they must only be carried out by qualified technical
personnel.
It is obligatory to contact your retailer or the manufacturer.
The maintenance operations listed here are to be carried out periodically.
The intervention times listed in this manual are purely indicative and refer
to normal conditions of use. Take these times into account and if
necessary, carry out the recommended checks on a more frequent basis.
Montly Maintenance Operations
EXTERNAL Cleaning
Wash the outside of the refrigerator with lukewarm water, wipe
over with cold water and dry with a soft cloth. Do not use
abrasive products.
INTERNAL Cleaning
Remove the grids, containers, and ice trays. Clean the
refrigerator with a little bicarbonate of soda or vinegar diluted in
lukewarm water.
Rinse and dry carefully with a soft cloth. Never use abrasive
products, detergents or soap.
Yearly Maintenance Operations
CONDENSER
Cleaning
Clean the condenser with a vacuum cleaner or a dry soft brush
(Fig.9).
GAS PIPE Check
Check the entire GAS supply pipe for cracks and/or leaks.
FIXING Check
Check the integrity of the seal between the refrigerator and the
compartment.
Maintenance Operations to carry out as required
GAS
PIPE
Replacement
Replace the GAS supply pipe before the expiry date printed on
the pipe.
Tab. 1
Standby
At the end of the season and in the event that the refrigerator is to remain
idle for a long period, it is necessary to carry out the following operations:
Position the switches “1””2” and “6” to the “O” position and set
the GAS knob “9” to the OFF position (Fig.3).
Close the central valve on the vehicle.
Empty the refrigerator completely.
Defrost the refrigerator and carry out general cleaning
operations.
Leave the freezer and refrigerator doors slightly open
.
