Vitronics Soltec 42284, Installation Manual

ICON

DESCRIPTION

ICON

DESCRIPTION

Only Qualified personnel is allowed to work on the 
equipment.
Never eat, drink or smoke while working on the 
machine.
Wash thoroughly before eating, drinking or smoking.

High voltages are present on various parts of the sys-
tem. 

Before working on the electrical circuit, turn main 
power off and block the mainswitch with a padlock.

Always wear heat resistant gloves and protective 
clothing when working on the machine.

If possible allow the machine to cool down before 
starting working on the machine.

When burned, immerse in cold water immediately. 
When the burn is severe, consult a physician as soon 
as possible.

Always wear heat resistant gloves and protective 
clothing when working on the machine.

If possible allow the machine to cool down before 
starting working on the machine

When burned, immerse in cold water immediately. 
When the burn is severe, consult a physician as soon 
as possible.

No smoking or open fire near the machine.

Be sure a fire-extinguisher is in the surroundings of 
the machine.

No smoking or open fire near the machine.

Be sure a fire-extinguisher is in the surroundings of 
the machine.

All moving parts of the system, including pulleys, 
belts, chains, coolingfans, sprocketwheels, vacuum-
doors and cylinders presents a potential danger.

Be careful with covers and doors. Always pay atten-
tion to opening and closing.

The vapours in the board preparation module are 
chemical. When the board is heated, a noxious 
vapour will be liberated. This vapour must be 
extracted. Also the dust on the surface of the solder-
pot is dangerous when inhaled.

Avoid inhaling this vapours / dust by using mouth 
protection. 

When working on the machine, always protect your 
eyes with safety glasses.

Nitrogen

N

2

Follow the safety precautions and procedures 
described in the 

Material Safety Data Sheet

 of 

the Nitrogen supplier.

UPS

Uninterruptible 

Power Source

When mainswitch is switched OFF for a longer 
period, switch the UPS to OFF.

Signal light RED
- E-stop Active

Signal light GREEN 
- Steady = Machine Run, 
- Flashing slow = Machine not at setpoint, machine 
stop

Signal light ORANGE
- Steady = Overload (outfeed full), Machine will 
block, 
- Flashing slow = Alarm
- Flashing fast = Critical alarm. Machine will block

LASER RADIATION
Do not stare into beam. 
Class 2 Laser product.

Only applicable for Soldering machines 
equipped with laser measurement systems.

If these rules are not observed it can cause personal injury and/or damage to the machine

SAFETY RULES

GENERAL INFORMATION