26
Noisiness
Propeller breakup
Small lesions: reparation allowed only
for experienced person. Otherwise
substitution..
Components' breakup (es. muffler,
bearings, bracket)
Check the motor. Don't use the motor
up to the problem has not been
identified and resolved.
Soundproofing material worn out
Replace it
Gasket connection exhaust/silencer
Replace it
Model Easy100: belt dirty, low tension or
worn out
Cleaning, right tension or replace it
Model Fly100evo:
lack of oil in the
reduction drive
Replace oilseals and 20cc of oil
Model Fly100evo: bearings or gearings
worn out
Replace it
Model Fly100evo: clutch worn out
Replace mass of the clutch
Sudden turning off
Aspiration of air from the circuit tank-
bulb-filter-carburetor
Check the junctions or replace the aged
pipeline or bulb
The spark-plug is worn out or defective
Substitution
The spark-plug has soot in the electrode
Clean it with an iron brush or replace it.
The cap of the spark-plug is not well
installed with the cable
Checkup or replace the cap.
The electric plant
Check there are no cables or wiring worn
out or open.
Check the correct installation.
The ignition coil or the contact breaker
has a problem
Replace it
Overheating
See section above: overheating
Carburetor problem
Get off and inspect
Strongly smokiness from the silencer
The gasoline in the tank has a wrong
percentage of oil
Void the tank and replace it
Wrong carburation
Restore the standard carburation
Soundproofing material worn out
Replace it
Leaking of oil
Connection cylinder to exhust pipe
Replace the two o-rings
Connection exhaust pipe to silencer
Replace gasket
Silencer
Clean the silencer with thinner, replace
the soundproofing, add sealing paste on
the junctions
Reduction drive Fly100evo
Replace oilseals
Crankcase, oilseals, o-rings or gaskets
Dismount, clean the plains, replace the
worn out components, add sealing paste
where necessary.
