Moster 185 Factory R - Maintenance manual - V1
72
Position the flywheel on the crankshaft by aligning the key with the flywheel groove. The position
of the key and therefore of the flywheel determines the timing of the engine.
Replace the nut M10x1,25 and the washer 10,5x18.
Insert the nut M10x1,25 with the washer 10,5x18 and tighten with the torque shown in the figure.
Add Wurth paste 0893921501 to the screws M5x20.
Insert the coil (3) and the 2 Allen screws M5x20 (1) with washers (2) without tightening.
Place 0,3 mm shims between the coil and the flywheel.
Tighten the coil screws by hand.
Remove the shims.
52 Nm
Summary of Contents for Moster 185 Factory R
