UR S2 UNIVERSAL TV- DVB CONTROLLER
Vivanco GmbH, D-22926 Ahrensburg, E-Mail
:
hotline@vivanco.de
,
1
(GB) Instructions
1
(D) Bedienungsanleitung
3
(F) Notice d’emploi
5
(E) Instrucciones para el uso
7
(I) Istruzioni per l’uso
9
(NL) Gebruiksaanwijzing
11
(PL) Instrukcja obsługi
13
(CZ) Návod k obsluze
15
(P) Manual de instruções
17
(N) Bruksanvisning
19
(DK) Betjeningsvejledning
21
(S) Bruksanvisning
22
(FIN) Käyttöohje
24
(RUS)
Руководство
по
эксплуатации
26
(GR)
Οδηγίες
χρήσης
28
(SK) Návod na obsluhu
31
Vivanco Addresses
33
(GB) Instructions
VIVANCO UR S2 Remote Control
Inserting the batteries
Open the battery flap on the back of
the remote control, press the tongue
lightly downwards, then insert 2
alkaline AA batteries. Check that the
polarity markings on the batteries and
in the battery compartment are
correctly lined up (+=+), then close the
flap
carefully.
–
Always
use
undamaged batteries.
Adapting to appliances
In order to control e.g. your TV or DVB
you must adapt or set the remote
control to it. There are two ways of
doing so: direct control code entry or
code search.
Direct control code entry using the
enclosed list
Example: setting to control a
Panasonic television set:
1.
The attached list gives, for
example, the Panasonic Code 176.
Please make sure you have selected
the correct list for television sets (TV).
2.
To prepare code entry,
press the
SET
button, keep it pressed
and then press the required appliance
button, e.g.
TV
, additionally until the
lamp (LED) lights constantly.
3.
Then press the number
buttons (e.g. 1 7 6) in sequence.
4.
Once the numbers have
been entered the lamp goes out and
the remote control is ready to control
your appliance.
5.
Finally, test the control
code setting by trying to control (in this
example) your television set. If it does
not work at all or not correctly try a
different code from the list or the code
search (see below).
You can terminate the mode by
pressing any device button.
