UR S2 UNIVERSAL TV- DVB CONTROLLER
Vivanco GmbH, D-22926 Ahrensburg, E-Mail
:
hotline@vivanco.de
,
2
Code search
If the brand of your appliance is not in
the list or none of the codes given fits,
we recommend a code search.
Manual code search
1.
Switch on the appliance to
be controlled. Program is running.
2.
To prepare code search,
press the SET button, keep it pressed
and then press the required appliance
button, e.g.
TV
, additionally until the
lamp (LED) lights constantly.
3.
Then point the remote
control at the appliance to be
controlled.
4.
Briefly press the
SET
button once. The lamp (LED) blinks.
5.
Press the ON/OFF
(appliance on/off) button repeatedly
for testing the next code, approx.
every 1,5 seconds, until the appliance,
e.g. your TV reacts by power off.
-
If your appliance has switched itself
off you must switch it back on again,
e.g. on the appliance or with the
original remote control, to continue
searching. - When your appliance
reacts you can also try out other
buttons without interrupting the
search. If some buttons do not work
properly, simply continue searching
with ON/OFF.
6.
When
your
appliance
reacts correctly, press the appliance
button, e.g.
TV
, and end the search.
The lamp (LED) goes out.
- The
UR S2
continues with the search
at the point where you interrupted it. .
The code last entered remains stored.
The search stops after approx. 30
seconds of inactivity.
Automatic code search
Your remote control finds the correct
settings almost automatically in
seconds:
1.
Switch on the appliance to
be controlled. A channel number, for
example, appears in the display of
your satellite receiver.
2.
To start the code search,
press the required appliance button,
e.g.
DVB
briefly.
3.
Then press
SET
for about
5 seconds until the lamp (LED) starts
to blink.
4.
Then point the remote
control at the appliance to be
controlled while the remote control
emits a different ON/OFF signal every
second.
5.
When
your
appliance
reacts, press
SET
within 1-2 seconds,
to end the search. –
If you ended the
search too late, continue to search
using the Manual Code Search (see
above).
6.
Finally, test the control
code setting by trying to control, for
example, your DVB appliance. If it
does not work correctly, please try the
code search again. The code search
then begins with the next code in the
sequence. -
Remember to switch your
appliance, e.g. DVB, back on again if
you wish to continue searching.
Code identification
You can read off the 3-digit codes you
have set at any time:
1.
Press the appliance button
of the appliance which code you want
to read off, e.g.
TV
.
2.
Press the
SET
button and
1,2,3, depending on the part of the
code you want to read off. For
example, if you press
SET
+
1
after TV
and the code 176 (in this example)
has been set, the lamp blinks once
after
SET+1
is released to show that
the hundred figure is 1.
All
you have to do is count. The ten figure
is indicated after
SET
+
2
is released,
e.g. it blinks 7 times for the 7 in 176.
The one figure is indicated after
SET
+
3
is released, e.g. it blinks 6
times for the 6 in 176.
-
Please
open
the
battery
compartment and write down the
found codes, for later use, onto the
sticker placed at the innerside of the
compartment door.
