Copyright © 2004, Vivato, Inc.
Vivato Wi-Fi AP/Bridge User Guide
65
Network Settings
Network Configuration Web Pages
Network>Ethernet Interface
The following settings can be configured for the wired Ethernet interface:
•
State
: Select ENABLED or DISABLED to use or disable this interface.
•
IP Address
: If needed, enter an IP address for this interface. Remember, if this interface is
part of the default bridge (br0), the IP of bridge 0 should be used as the IP of the AP/Bridge
to access it from another device; so this field would be left set to “none”.
•
Netmask
: Enter the subnet mask for this interface.
•
Secondary IP Address
: Enter a secondary IP address for this interface.
•
Secondary Netmask
: Enter the subnet mask for the secondary IP address.
•
RX/TX PACKET INFORMATION
: Refer to
"show interfaces wireless <0-1>"
After editing settings, select
Edit
to put the changes into effect.
Figure 11—
Editing The Ethernet Interface Settings