VIVAX
ENG
8
2. Put three tablespoons of finely ground
coffee or four tablespoons of regular
ground coffee into the filter for a full cup of
coffee
Note: regular coffee grounds require more
coffee per cup to achieve the strength of finer
coffee grounds.
3. Gently shake the filter to distribute the
coffee evenly.
4. Place the filter into the funnel and place
filter into the brewing chamber (see the
figure)
5. Take water in the tank, making sure that
the water level is not higher than “Max”
level.
6. Close the top lid.
7. Remove the lid from the cup and place the cup into the base.
8. Plug the power cord into a standard 220-240volt AC electrical outlet.
Press the
ON/OFF
button. The
Red
On LED light will light up to indicate
the brew cycle has started.
9. When the brewing process ends and the water level indicator is empty,
there will still be hot liquid in the filter. Wait a few minutes for the rest
of the liquid to drip through into the cup
.
10. After coffee grounds have cooled, open the top cover and carefully remove
the filter by grasping the handle and lifting straight up from the Funnel
compartment. Discard used coffee filter and grounds.
Note: brew cycle has been completed, indicator light will be closed, the
machine will not heat. LCD display the current time
Caution
: Don’t open the reservoir lid during the brew cycle, as scalding
may occur.
11. Allow all the coffee to drip from the brewing chamber into the mug before
removing the mug.
Note: since coffee grounds absorb some water during brewing, the amount
of brewed coffee will be slightly less than the amount of water pure didn’t
other reservoir.
12. If brewing another mug of coffee at this time proceed to the brewing a
second mug of coffee section, when all brewing is complete, unplug the
power cord from the electrical outlet.
Summary of Contents for CM-700TG
Page 64: ...www VIVAX com ...
