ENG
VIVAX
15
◆
For the first time you install your refrigerator, set the thermostat knob at “
MID (2-3)
”
(middle position).
Give your freezer time to cool down completely before adding food. It is the best to wait
24 hours before adding food. The thermostat knob controls the temperature.
◆
When the Thermostat knob is turned up to the end position, below the "MIN" (1)
position, the Refrigerator will stop cooling
.
WARNING: In the lowest Thermostat position, although the fridge is not cooling,
it does not mean that the device is disconnected from the power supply. For
cleaning and maintenance, to disconnect the power supply pull the power plug
out of the socket!
Noise Inside the Unit!
You may notice that your unit makes some unusual noises. Most of these are perfectly
normal, but you should be aware of them!
These noises are caused by the circulation of the refrigerant liquid in the cooling system. It
has become more pronounced since the introduction of CFC free gases. This is not a fault
and will not affect the performance of your unit. This is the compressor motor working, as it
pumps the refrigerant around the system.
Change the Light Bulb (if exists)
The LED lamp must be replaced by authorized service. Please contact authorized service
or manufacturer.
Maintenance
Cleaning
Please unplug the Freezer for defrost and cleaning
Dusts behind the freezer and on the ground shall be timely cleaned
to improve the cooling effect and energy saving.
The interior of the freezer should be cleaned regularly to avoid
odor. Soft towels or sponge dipped in water and non-corrosive
neutral detergents are suggested for cleaning. The freezer of shall
be finally cleaned with clean water and dry cloth. Open the door for
natural drying before the power is turned on.
◆
Remove all the shelves.
◆
Wipe the inside of the unit with a weak solution of bicarbonate
soda and then rinse with warm water using a “wrung-out”
sponge or cloth. Wipe completely dry before replacing the shelves and salad bin.
◆
Use a damp cloth to clean the exterior, and then wipe with a standard furniture polish.
Make sure that the door is closed to avoid the polish getting on the magnetic door seal
or inside the unit.
◆
The grille of the condenser at the back of the unit and the adjacent components
can be vacuumed using a soft brush attachment.
Summary of Contents for TTF-68
