Features
Temporary and Permanent Hold Feature
When cool or heat is turned on, the thermostat will display
HOLD
and
RUN SCHED
on the left of your screen when you press the
or button.
Temporary Hold
: At this time if you do nothing, the temperature will
remain at this setpoint temporarily for 4 hours.
Permanent Hold
: If you press the
HOLD
key on the left of your
screen, you will see
HOLD
appear below the setpoint temperature in
the display. The thermostat will now permanently stay at this
setpoint and can be adjusted using the or keys.
To Return to Running Schedule
: Press the
RUN SCHED
button on
the left of your screen to exit either temporary or permanent hold.
Filter Change Reminder
If your installing contractor has configured the thermostat to remind
you when the air filter needs to be changed, you will see
FILT
in the
display when your air filter needs to be changed.
Resetting the filter change reminder:
When
FILT
reminder is
displayed, you should change your air filter and reset the reminder
by holding down the second button from the top left side of the
thermostat for 3 seconds.
(If using programming)
Gently slide a screwdriver into the
bottom edge of the badge. Gently turn
the screwdriver counter clockwise. The
badge is held on by a magnet in the well
of the battery door. The badge should pry
off easily.
DO NOT USE FORCE.
About The Private Label Badge
All of our thermostats use the same universal magnetic badge. Visit the
company website to learn more about our free private label program.
Magnet in door
Use the bevel on lower ridge
Set Time
1.
With system switch set to OFF, press the
MENU
button
2.
Press
SET TIME
3.
Day of the week will be flashing. Use the or key
to select the current day of the week.
4.
Press
NEXT STEP
5.
The current hour is flashing. Use the or key to
select the current hour. When using 12-hour time, make sure
the correct a.m. or p.m. choice is selected.
6.
Press
NEXT STEP
7.
Minutes are now flashing. Use the or key to
select current minutes.
8.
Press
DONE
when completed.
(If using programming)
Programming
Specifications
The display range of temperature ... 41˚F to 95˚F (5˚C to 35˚C)
The control range of temperature.... 44˚F to 90˚F (7˚C to 32˚C)
Swing (cycle rate or differential) ...... Heating is adjustable from 0.2˚ to 2.0˚
Cooling is adjustable from 0.2˚ to 2.0˚
Power source ...........................................18 to 30 VAC, NEC Class II, 50/60 Hz
for hardwire
Battery power from 2 AA Alkaline
batteries
Operating ambient ............................... 32˚F to +105˚F (0˚C to +41˚C)
Operating humidity .............................. 90% non-condensing maximum
Dimensions of thermostat ................. 4.7”W x 4.4”H x 1.1”D
Specifications
