5
Flip open the LCD screen and power on the camera. When powering the camera ON
for the first time
the camera will take you through the initial camera setup.
Powering the Camera ON
1)
Installing the Batteries
Remove the battery compartment cover.
Insert the batteries properly into your digital camcorder, according to the polarity shown inside
the battery compartment.
Close the battery compartment cover securely.
Use 3 x AAA (1.5V) batteries. Alkaline batteries are recommended. (Batteries not included.)
Note:
Remove the batteries from the camera when not in use for an extended period.
Do not mix alkaline and non-alkaline batteries.
Some camera features (i.e. Flash) will not work if the battery power level is low.
When the battery power is low, the battery icon appears empty and
‘Battery Low’ appears on
the LCD screen. The camcorder automatically turns off a few seconds later.
The energy status of the power is displayed on LCD as shown below:
Full battery power
Medium battery power
Low battery power
2) Installing the SD Memory Card
Make sure the SD Memory card (up to 32GB) has been properly inserted into your digital
camcorder. SD card not included. To properly insert the SD Card:
- Push the SD card into the slot in the direction shown on the digital camcorder.
- Push the SD card until you hear a slight clicking sound. This indicates the SD card has been
inserted correctly.
Note
:
After the digital camcorder is powered on, an SD icon appears on the LCD display. If you do
not see the SD icon on the display, please check if the card was inserted properly.
Make sure the SD card is not locked (check the lock switch on the side of
the SD card). If the SD card is locked this will prevent the digital camcorder
from saving captured photos to the SD card.
