31
3.On-Screen Display (OSD) Menu Settings
USER MANUAL
Vivitek - D366 Series
User Manual v1.1
IR Control
●
Use ◄/► to select the prefered IR control location (Both IR On Front IR on, Rear IR On)
This function let you select which IR remote controller receiver is active.
Remote ID
Display current projector ID and remote control ID number. To set a unique ID for the projector and
control independently.
HDBaseT
●
Use ◄/► to switch HDBaseT_RS232_RJ45 ON/OFF Enable the control function of HDBaseT with
RS232 and RJ45,
Network
Use this function to configure the network settings, so that you can control the projector via the
network.
●
Press
and use ▼/▲ to scroll through submenus
●
Network State:
Connect / Disconnect the network automatically.
●
DHCP:
use ◄/► to Set DHCP to ON/OFF.
When DHCP is set to ON, the DHCP server of the domain will assign an IP address to the
projector. The IP address will appear on the IP address window without applying any input. If the
domain cannot assign any IP address, 0.0.0.0 will be shown on the IP address window.
●
IP Adress:
Press
to show the IP address input window.
Use ◄/► to select the number in the address to change
Use ▼/▲ to increase or decrease the number in the IP address.
(Example :Network IP Address 172. xxx. xxx. xxx.)
●
Subnet Mask:
Set the subnet mask. The input method is the same as the setting for IP address.
●
Gateway:
Set the gateway. The input method is the same as the setting for IP address.
●
DNS:
Set the DNS. The input method is the same as the setting for IP address.
●
Aply:
Press
and use ▼/▲ to scroll through submenus
