DLP Projector—User’s Manual
Rear view
D
I
TEM
L
ABEL
D
ESCRIPTION
S
EE PAGE
:
1.
VGA1 IN
Connect a RGB cable from a computer or a video enabled device
2.
POWER
Turns the projector on or off (main power switch must be
turned on first). Press to place the projector in standby mode.
Red Standby
Green In
normal
mode
3.
PWR LED
Flashing
Error code (See as LED indicator table)
4.
TEMP LED
Red
Over temperature
Red In
normal
mode
5.
READY LED
Flashing
Error code (See as LED indicator table)
6.
RJ-45
Connect a LAN cable from Ethernet
7.
VGA2 IN
Connect a RGB cable from a computer or a video enabled device
8.
HDMI
Connect the HDMI cable from a HDMI device
9.
D
I
SPLAYPORT
Connect a DISPLAYPORT CABLE to a DISPLAYPORT source
10.
USB
Connect the USB cable from a computer
11.
VGA OUT
Connect the RGB cable to a display
(Pass through by VGA1 only)
12.
AUDIO IN
Connect an AUDIO cable from the input device
13.
IR receiver
Receive IR signal from remote control
14.
SERIAL
Connects RS-232 serial port cable for remote control
—
4
—