2
3
Phillips
Screwdriver
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual and do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or
inappropriate use.
TOOLS NEEDED
ASSEMBLY STEPS
STEP 1
WARNING!
PACKAGE CONTENTS
A
(x1)
Laptop Tray
Assembly
B
(x6)
Mounting Screw
STEP 2
Remove screws and bumpers from the end
of the slider track with a Phillips screwdriver,
then remove the laptop tray.
STEP 3
Place slider track against the underside of the
desktop and mark drilling locations. Please
note, the desk must have a thickness of at least
3/4" (19mm).
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
11 lbs
(4.99 kg)
Drill
Rotate slider track and slide toward the
front of the laptop tray (
A
).
STEP 4
STEP 6
Insert screws
(B)
into the front-right and rear-
left holes, leaving 0.2" (5mm) of screw thread
exposed.
STEP 5
Place track on desk with the keyholes fitting over
the screw heads, then slide back and tighten
screws.
Drill 0.59" (15mm) deep holes using a 5/32" or
4mm drill bit.
STEP 7
STEP 8
STEP 9
Adjust laptop tray height if needed by removing
screws and washers from the sides, then rein-
stall at the required height.
Slide the laptop tray back into the track and
reinstall previously removed screws and
bumpers.
Secure track using the rest of the screws
(B)
.
Step 10
Adjust laptop tray depth by loosening the knobs
underneath.
STEP 11
Adjust as desired.
